If you are looking to buy or make your own Christmas tree, one of the best things you can do is to use a 5-foot Pre Lit Pole. These are perfect for indoor use at home because they are very easy to install and use. They are also ideal if you want a small but colorful Christmas decoration that is easy to place and move around. The best thing about these lights is that they come with an LED light, which means that the light will last much longer than regular lights.
When it comes to Christmas tree decorations, many people choose ones that are very ornate. While it is nice to have a huge tree with a million lights, this option is quite expensive. By using a simple Christmas pole with one LED light, you can keep it very simple yet still have an elegant look.
So how do you install a 5-foot Pre Lit Christmas Tree? To begin with, you need to make sure the tree is very straight. You do not want your tree to be wavy because it will look funny. The easiest way to do this is to use a light weight tape measure. Once you have the height of the pole measured, tape it to the wall so that the light is directly above the ground level. Then cut out strips of light-colored cardboard, which should be one inch larger than the actual size of the pole.
Next, attach one end of the strip of paper to a stud in the wall. You may need to screw the studs into the wall. Use your thumb and nails to hold the other end of the strip tight against the stud, so that the light is securely in place.
After that, take some strips of LED lights and run them along the studs you just created. Make sure the lights are firmly held in place and that they are all the same color. If there are any in the middle of the strip, cut them off, and then re-attach the stud in the wall.
Once that is done, you can attach the LED lights to the tree. Do this by cutting a piece of board the same size as the pole, and using electrical tape to hold everything in place. When you are attaching the lights to the tree, it is better to have an adult help you hold down the lights. It is a good idea to have someone watching the display, just in case there is a mistake or something goes wrong. This can happen if the lights are too close together, or if there are tangled wires.
Once the lights are in place, secure the pole with some electrical tape. Then, insert some festive plastic flowers inside the tree house, and then close it up. Place a big ribbon at the top, and trim the rest back. Your tree should be completely covered, but try not to cover the bottom of the pole with the ribbon. Instead, fill in the hole at the top with some sand, and then add some pine cones.
Make sure to check your tree after Christmas to make sure everything is where you want it. Take the ribbon and plastic flowers out before you start the lighting process to ensure that they will be in place at all times. The lights are powered through 12V batteries that you should buy or buy batteries at your local store. These batteries last a long time, so be sure to change them every year. Also, be careful to keep the lights away from the windows and doors, which could cause damage over time.